Toolhead
09-05-2018, 01:48 PM
recently inspected the flex 3401...
all is good but after taking the backing plate off..i noticed some surface rust on the internal metal housing...
metal housing being the metal body of the flex visible once removing the backing plate.
anyone else seeing this on theirs and if so...doing anything about it? coating in light oil for prevention etc?
all is good but after taking the backing plate off..i noticed some surface rust on the internal metal housing...
metal housing being the metal body of the flex visible once removing the backing plate.
anyone else seeing this on theirs and if so...doing anything about it? coating in light oil for prevention etc?