View Full Version : HD Cut+ VS Menz 400
Ronin47
07-17-2018, 11:16 AM
For those that have used both, your thoughts? I’m quite familiar with 400.
Ronin47
07-18-2018, 05:19 AM
Guess noone uses HD Cut+
dlc95
07-18-2018, 07:37 AM
If I remember mwoywood correctly, he said it wasn't the heaviest cutter.
I can't say for sure because I've never used HD Cut + myself.
400 has been good to me, so I guess I'd never had a reason to try anything else.
i know that's not helpful haha.
derass
07-18-2018, 09:49 AM
Maybe 3D One will be more comparable to Menzerna HC400.
Ronin47
07-18-2018, 09:51 AM
I use 400 as a benchmark when comparing cut and finish and assume Cut+ is in that range.
BudgetPlan1
07-18-2018, 11:53 AM
Can't pinpoint exact threads but I seem to recall many saying that HD Cut+ is on the 'lighter' end of compounds, cut-wise.
Ronin47
07-18-2018, 01:49 PM
So the consensus is less cut than 400?
Kamakaz1961
07-18-2018, 02:38 PM
FG400 is my Go-to compound product. Can't comment on any HD products. Sorry
DaveT435
07-18-2018, 02:48 PM
Cut+ is actually designed for rotary use, obviously you can use it with either, it's much more effective with a rotary. I believe 400 is designed more for both rotary and DA.
Ronin47
07-19-2018, 02:20 AM
Cut+ is actually designed for rotary use, obviously you can use it with either, it's much more effective with a rotary. I believe 400 is designed more for both rotary and DA.
According to AG site, Cut+ is for both rotary and DA.
WRAPT C5Z06
07-19-2018, 08:47 AM
According to AG site, Cut+ is for both rotary and DA.
It's designed for both. I don't think you'll see a huge difference between the two compounds.
Ronin47
07-20-2018, 01:31 AM
Thanks, have enough similar cut compounds, will give it a skip.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.