Electric Random Orbital sander

[Strat]

Can an electric orbital sander like the one linked below be successfully used as an alternative to an air DA for using sanding discs for deeper scratches?

Makita BO5041K 5-Inch Random Orbit Sander Kit - Power Random Orbit Sanders - Amazon.com (https://www.amazon.com/Makita-BO5041K-5-Inch-Random-Sander/dp/B003M5IWM8/ref=sr_1_7?ie=UTF8&keywords=orbital+sander&qid=1515241372&s=power-hand-tools&sr=1-7&tag=tutina-20)

[BillyJack]

I wouldn't do it. Look at the speed range for that tool, 4,000-12,000 OPM. Even the lowest speed setting is roughly the equivalent to speed "5" on a D/A polisher, mush faster than you would normally use to damp-sand paint.

Bill

[subyfan]

Can an electric orbital sander like the one linked below be successfully used as an alternative to an air DA for using sanding discs for deeper scratches?

Makita BO5041K 5-Inch Random Orbit Sander Kit - Power Random Orbit Sanders - Amazon.com (https://www.amazon.com/Makita-BO5041K-5-Inch-Random-Sander/dp/B003M5IWM8/ref=sr_1_7?ie=UTF8&keywords=orbital+sander&qid=1515241372&s=power-hand-tools&sr=1-7&tag=tutina-20)I did a full cut and buff on my DD a while back and used 3"/6" 3M Trizact discs paired with my PC 7424XP and it worked absolutely beautifully. I would suggest doing your final pass (3000 or 5000 grit) with a small throw finishing DA though. I used my pneumatic DeWalt palm sander for this. IMO if you're going to be paying for a sander and already have an air-DA, you should just get a PC. Capable, well-built tool and can be used for polishing to perfection as well, which the linked tool cannot.

Sent from my SM-G955U using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)

[Strat]

Thanks for the advice.
I am so new to this. I thought a higher speed would be better. ��
Sadly I don't have an air compressor.
Could i use my rotary polisher or is a DA more prefereable?

[subyfan]

Thanks for the advice.
I am so new to this. I thought a higher speed would be better. ��
Sadly I don't have an air compressor.
Could i use my rotary polisher or is a DA more prefereable?I would not recommend using a rotary for any type of cutting, unless you're intending to strip to bare metal for a respray. Lol. The action of the DA is much more gentle than a rotary. If this is your first time sanding clear coat, I would highly recommend that you research THOROUGHLY how to wet sand by hand/by machine and make sure that you understand just how thin the clear coat on a factory paint job is. Wet sanding should not be taken lightly, as if you break through to the base coat, the only repair method is a full repaint of the panel. There are many great resources on AGO about this topic. Just do a search for wet sanding or machine sanding clear coats.

Sent from my SM-G955U using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)