Scratch under coating

[C5Longhorn]

As I am always close by to Murphy and his law, I noticed a scratch right after I finished applying my coating of Uber ceramic.

Can I polish out the scratch and reapply the coating to the affected area? I would tape off a section, correct, and then recoat.

Appreciate any input.

Rick

Sent from my Pixel XL using Tapatalk

[TTQ B4U]

Yes, you can. Wet sand where needed, polish the area, wipe down if applicable and re-coat. I just touched up some areas on our van the other day.

[C5Longhorn]

Great, thanks for the quick reply. Much appreciated.

Sent from my Pixel XL using Tapatalk

[DaveT435]

If your always close to Murphy and his law you may not want to do any wet sanding unless your experienced.

[C5Longhorn]

Agreed, I would correct with a DA and M105/205.

Sent from my Pixel XL using Tapatalk

[Mike lambert]

You may want to just re do the whole panel, following his law, if there's one there's 2?

[C5Longhorn]

It's a Viper hood, so hopefully don't have to redo the whole thing as it's the biggest panel on the car.

Sent from my Pixel XL using Tapatalk