View Full Version : griots microfiber and pad cleaner during detail?
fightnews
11-24-2016, 06:06 AM
can u put some pad cleaner in a spray bottle and mist it on to clean pads in between panels on the fly?
I would just get more pads.Or clean it on the fly how Mike Phillips tought with out any cleaner.
Mike lambert
11-24-2016, 07:35 AM
I would not, blowing out after each pass is better if you can.
TTQ B4U
11-24-2016, 08:13 AM
use air or a small brush and fluff as you go. i normally change pads ever 2 panels and as I go I tend to spin them against a small brush to clean and fluff them as I move along.
fightnews
11-24-2016, 08:30 AM
I would not, blowing out after each pass is better if you can.
i could set something up for that
Mantilgh
11-24-2016, 08:54 AM
I believe the pad cleaner would probably need to be rinsed from the pad and the pad dried before using again. I could be wrong though
fightnews
11-24-2016, 09:58 AM
I believe the pad cleaner would probably need to be rinsed from the pad and the pad dried before using again. I could be wrong though
i think ur right im just going to clean it the usual way thanks
goldenlight
11-24-2016, 11:44 AM
I usually use 3 pads to clean a midsize car.. I havn't personally tried this.. But maybe you can clean the pads then used the polisher at full speed to help dry the pads.
fightnews
11-25-2016, 05:18 AM
I usually use 3 pads to clean a midsize car.. I havn't personally tried this.. But maybe you can clean the pads then used the polisher at full speed to help dry the pads.
thats not a bad idea
WRAPT C5Z06
11-25-2016, 10:53 AM
Blow out with a compressor or use a pad brush after each pass.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.