3M Finesse-It K211 Any one use it?

[slovette99]

So 3M Finesse-It k211 came up on Amazon deal of the day. 1 Gallon for $53 shipped and retails for around $100. I couldn't pass it up but I couldn't find any reviews or anything on here of anyone using it. Anyone out there tried it and had any success with it? What pads and machine you using if so? Thanks!

[GSKR]

Depends on what your working on.personally I never cared for it.

[slovette99]

Depends on what your working on.personally I never cared for it.

What didn't you like about it exactly?

[GSKR]

Dries and sticks and with its high price tag back in the day didn't produce awesome results.

[slovette99]

So I tried it today. Honestly I thought it worked great. I tried it with a LC CCS green pad and it brought good results with just claying before. I wet sanded a junk hood with 1000, 1500, 2000, 3000, and 5000 trizact. The 5000 foam trisect i attached to my 3" backing plate and it stuck rather well then just trimmed off the excess with a razor blade. On half I used CG V32 and other half just the k211. They both came out pretty similar but the v32 was a little hazy. K211 side you could barely see some of the sanding marks. Which I used a yellow cvs cutting pad with the v32. I then went over the V32 side with K211 and to be honest it was ready for wax or sealant at that point. It didn't dry out, in fact the V32 dried out quicker than the k211. So anyone who reads this I would say its a decent product. Further testing will prove if it truly is. Thanks.