Reaply Wolfgang Uber Ceramic Coat over original first coat

[jeancaban]

Hello everyone.

I did all prep as recommended prior applying Wolfgang Uber Ceramic Coat, my concern is that I miscalculated the amount left on the syringe to finish the whole car. To at least cover most of the car, I applied the ceramic coat with a considerable smaller amount on the applicator pad compared with the already done on the first panels, all some parts of the car were coat at all (wheels, front and rear bumper). I reorder another syringe to finish the job.

My questions is, can I reapply a new coat to the panels that weren't covered with a correct amount of the product?

[mwoolfso]

I apologize in advance, no malice intended with my response. The language used here is a little confusing. I won't critique it but I can say nothing more then "You should be fine - so yes".

[jeancaban]

I apologize in advance, no malice intended with my response. The language used here is a little confusing. I won't critique it but I can say nothing more then "You should be fine - so yes".

No problem at all. English is not may main language, and also I used my cellphone to open this thread which is more prone to typing errors. But thanks anyway for your response.

Adding a little more detail to my concern regarding adding a second coat to some of the panels of my car. My problem was that I miscalculated the amount of product provided in syringe and after completing around 70% of the car, there wasn't product left in the syringe to evenly apply the product to the rest of car. To finished the task I just reorder a second syringe of Wolfgang Uber Ceramic Coat and wanted to know if I can apply a second coat without problems over the 30% of the panels so the ceramic coating is evenly distributed on 100% of the car.