jimbob
04-30-2016, 04:24 PM
Hi all, I applied a coat of BFWD followed by two layers of BF midnight sun just over a month ago.
I've been SUPER impressed with the looks, by far the best product I've used in that department. But I'm not terribly impressed with its water behaviour. We're heading into winter soon here in Australia so I'm looking to strip the BFWD and apply an LSP which (imo) has more favourable water properties.
My question is, is Blackfire gloss enhancing polish sufficient in removing the BFWD and MS? I'm only intending to do a once over with the polish. Would any additional steps to remove the old sealant be required? Not planning on claying and using abrasive polish as the paint is in satisfactory condition.
Also, since the new sealant is not from the blackfire family would an IPA wipe down be required post glaze/polish and pre LSP?
Thanks
I've been SUPER impressed with the looks, by far the best product I've used in that department. But I'm not terribly impressed with its water behaviour. We're heading into winter soon here in Australia so I'm looking to strip the BFWD and apply an LSP which (imo) has more favourable water properties.
My question is, is Blackfire gloss enhancing polish sufficient in removing the BFWD and MS? I'm only intending to do a once over with the polish. Would any additional steps to remove the old sealant be required? Not planning on claying and using abrasive polish as the paint is in satisfactory condition.
Also, since the new sealant is not from the blackfire family would an IPA wipe down be required post glaze/polish and pre LSP?
Thanks