Best outcome with sealant?

[BrianJM]

Hey guys before I apply a sealant what should I wipe down with before hand to get the best results? Also I had a question as far as dusting. When I get done doing correction work and there is dusting what is the best way to get rid of it all? Wash the car again or what?

[FUNX650]

Hey guys before I apply a sealant
what should I wipe down with before
hand to get the best results?
IMO:
•It's best to follow the manufacturers'
recommendations/directions/instructions.

-If there is no mention, from them, specifying
a "wipe-down"...then I don't perform one!



Bob

[BrianJM]

IMO:
•It's best to follow the manufacturers'
recommendations/directions/instructions.

-If there is no mention, from them, specifying
a "wipe-down"...then I don't perform one!



Bob

I guess you can't really go wrong with that. Thanks bud

[zx10r Elle]

Mr BrianJM,


In general for sealants ( synthetics/silicones ) there has been some experimentation providing some proof their attributes improve with a 'paint prep' product, something along the lines of Eraser. That would also remove dusting at the same time.

As a comparison Optimum has us using OCW for removing any dusting, and it does that fine, but its not a 'paint prep' product so theoretically it would not improve sealant behavior.

Also if you are staying within the product line synergy this is also purported to improve product behavior.


Steve

[GSKR]

IF it's bad it's just easier to rinse it down.after every panel I polish I try to keep things easy by a wiping with eraser before sealant.But I rarely don't have a dusting promblem.