View Full Version : PC plug in place of handle
PaulMys
04-27-2016, 07:23 PM
Forgive me, fellas. I think (know) I've read this before, but damn if I can find it:
So when you remove the side handle on the PC, you need to replace it with a short plug or the shroud will come off?
This makes sense to me, and I can make (or probably have) a plug to fit, but just wanted to double-check with you guys.
Frank70
04-27-2016, 07:36 PM
If your date code is 2009-11 and newer you will need two metric M8 x 1.25 socket cap bolts. If your date code is 2009-10 and earlier you will need 2, 5/16 inch x 1/2 inch socket cap bolts and matching washers. If you have Mike Phillips book (The Complete Guide to a Show Car Shine) it's on page 53. Hope this is the info you are looking for.
Frank
PaulMys
04-27-2016, 07:56 PM
If your date code is 2009-11 and newer you will need two metric M8 x 1.25 socket cap bolts. If your date code is 2009-10 and earlier you will need 2, 5/16 inch x 1/2 inch socket cap bolts and matching washers. If you have Mike Phillips book (The Complete Guide to a Show Car Shine) it's on page 53. Hope this is the info you are looking for.
Frank
Well I'll be a ..............
THAT's where I saw it, dammit!!
Thanks, Frank. Appreciate it, man. :)
Frank70
04-27-2016, 08:03 PM
Well I'll be a ..............
THAT's where I saw it, dammit!!
Thanks, Frank. Appreciate it, man. :)
Not a problem. Glad to help.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.