PDA

View Full Version : Flex Polishers



Pages : 1 2 3 4 5 6 7 [8] 9 10 11 12 13 14 15 16 17 18

  1. My Flex 3401 - plan of selling it (again)
  2. ready to rotary or not?
  3. Flex anyone like the 6.5 pads the best?
  4. backing plate for the flex pe-14
  5. Reconditioned Flex 3401
  6. Da pads and rotors
  7. Ughhh why me always Handle issue
  8. Flex 3403
  9. Just bought a Flex
  10. Pads for standard backing plate on a 3401
  11. Thinkin of buying a flex
  12. Newbie to the DA polisher
  13. Flex locally for $275 w/8 CCS Pads. Good buy?
  14. Proper Speeds??
  15. Is this normal?
  16. 3401, how much of a time saver in reality?
  17. 7.5" pads with a Flex 3401. Go or No Go ?
  18. Both my Flex 3401's broke.
  19. Jeweling with the 3401
  20. Issues correcting messed up dealer prepped used car with Flex 3401
  21. Pulling trigger for a 3401
  22. scratches still there after using flex 3401
  23. Thinking of getting a Flex 3401 kit....not sure which one
  24. Low Profile LC HT 5.5 pads on a 3401?
  25. Just ordered my Flex 3401 Wolfgang kit!!!
  26. I'm about to Pull the trigger
  27. Pad sizes for flex plates 4", 5.5" and 6" ?
  28. Serviced flex.
  29. Opinions on Flex 3403 rotary
  30. SF4500 Menzerna + Flex 3401= speed?
  31. Tried Out My New Flex 3401 Today.
  32. LC Pads for Flex 3401
  33. Buying a flex kit... Need suggestions
  34. Flex XC 3401 Leaking Oil? Cleaning Procedures?
  35. FLEX XC3401 VRG 230 volt Orbital Polisher
  36. 3 inch Flex DA Orbital
  37. Flex pe14-2-150
  38. Flex hat/banner
  39. 3401 plate damage
  40. Flex PE 14-1 180
  41. 3401 Backing Plate Combo
  42. 4" backing plates works great.
  43. First 50 PE14 polishers??
  44. household uses for my new flex?
  45. I just purchased pe-14-2 and need suggestions on pads
  46. MF pads vs PFW pads on 3401
  47. overloading pad?
  48. Final Kit Purchase Decision, I hope?
  49. How steep is the learning curve with a Flex?
  50. flex pe14 2-150 get hot after 30min