The BEAST and the FINISHER! The New Official FLEX Tool Names!

[DaveT435]

ya that sux but you gotta remember you most likely got a defective one. you shouldnt base your opinion off that because its going to happen to some people no matter what. if they sell 50,000 machines and only 3 or 4% of them were defective that would be considered a very high quality machine even though up to 2000 people would get a defective machine. thats just how it goes with machines. id get another one and then if that chits the bed then id tell everyone they're junk and get my money back

I would have to say they had a lot of problems since they quit selling them and went back to the drawing board. I think it's been 4 or 5 months since they quit making the old ones and from what I can tell the release date on the new ones got pushed back to at least March, of course they seem to just keep pushing it back. On the positive side I assume they are making sure the revised version will be worthy of the Flex name.

[Dan Tran]

Pushed to march? Where did you hear that from?


Sent from my iPhone using Autogeekonline mobile app

[fightnews]

I would have to say they had a lot of problems since they quit selling them and went back to the drawing board. I think it's been 4 or 5 months since they quit making the old ones and from what I can tell the release date on the new ones got pushed back to at least March, of course they seem to just keep pushing it back. On the positive side I assume they are making sure the revised version will be worthy of the Flex name.

good point i was kinda thinking that too, they try to make it sound like they dont have any because the demand is so high

[Dan Tran]

Since the upgrade of the AGO app, I haven't been able to post pictures.

However, I was finally able to get to a computer. I have been meaning to post pictures of my new Polisher I won from this contest and some Pads I recently purchased since I was add it.

I promise to post a review about it when I can.

In the mean time, here is a sneak peak: