Quick question

[6LS2]

Hi there, just a question for you detailers. When polishing a car with the PC, how do you do areas like this?



Like under the spoiler, the area with the number plate is, etc.

Thanks.

6LS2

[Nuke33]

get as close as you can and then by hand or maybe use a edge pad but you can burn the paint if you run it along the edge

[justin30513]

Most PC pads have a rounded edge that allows you to get into these areas. You have to be careful though. The EDGE2000 system is really good at this. It takes time and a delicate hand to learn this though.


You can always come back with and do it by hand it uneasy with the use of a machine.

The only way to get under your spoiler is by hand.

[JTS]

Spot Buffing 4 inch pads


I use the 4 inch pads to get in some small places.

[6LS2]

Thanks guys, I was trying to figure out how I could do the underneath of the spoiler when I did a test spot on the trunk earlier. I took pics if anyones interested

[greg'sgoat]

I don't know how it is on your car, but to get under the spoiler on my car (if it was still on) would be to take it off. Ours is 4 easy to get to bolts and it comes right off. Then you can just go right over it with the PC.

[Jimmie]

PB PwS by hand.