Porter cable rpm's?

[dinkydow]

I ordered some of the edge pads and was reading up on how to install and use them etc. anyway it says not to go over 1800 to 2000 rpms. I am now drawing a blank as far as my porter cable is concerned. Does that mean I can't run the machine over the number 2? If that is not correct how do I know how many rpm's It is turning at? Thanks

[sparkie]

This was covered on page 2 and 3 at this link!

Is this me? Edge 2000

[BILL]

Originally Posted by dinkydow

I ordered some of the edge pads and was reading up on how to install and use them etc. anyway it says not to go over 1800 to 2000 rpms. I am now drawing a blank as far as my porter cable is concerned. Does that mean I can't run the machine over the number 2? If that is not correct how do I know how many rpm's It is turning at? Thanks

RPM for rotary machine

OPM for orbial p.c..........

[dinkydow]

orbital PC

[BILL]

Originally Posted by dinkydow

orbital PC

Thats OPM's you can use your P.C to the limit....RPM's do not apply....

[dinkydow]

Thank you for the info!!!

[joe.p]

Orbits per minute (OPM)