Hello guys,


I tried to polish very light swirls with Menzerna Final FInish, and it took forever but the polish still won't break down.

How long on average does the FInal finish take to completely break down?

I used a 3M black polishing pad, about 4 dots of polish on the pads, and worked on a 2x2 section (hood). I started with 600 rpm about 1-2 pass, followed by 900 rpm about 2-3 pass, 1200 rpm about 7-10 pass, back to 900 rpm about 2 pass. I polished the section for about 10 minutes and the polish doesn't even begin to dry, it's still wet.
I barely push the rotary with my left hand, but I just let it glide under its own weight. Could this be the part where I did wrong? Also, should I use higher rpm, 1500 rpm maybe ?

Thanks in advance guys! and thanks Mike!